CAM Toolpaths
Thread Milling, Keyholes, Undercuts, Surfacing & Laser
Machine helical internal/external threads, safe reverse-out keyhole slots, T-slot/dovetail/lollipop undercuts, flat spoilboards, drag-knife cuts, and diode laser jobs.
Beyond standard 2D routing, VibeCNC includes specialized mechanical, utility, and non-spindle toolpaths under Thread and Specialty+.
Thread Milling (Internal & External)
Select target circles and choose Thread in the Right Drawer to cut precise helical threads in aluminum, brass, acetal, or dense hardwood using a single-point or multi-form thread mill:
- Supports both Internal (female tapped holes) and External (male threaded bosses) with Right-Hand or Left-Hand pitch.
- Climb-mills from bottom up (recommended for rigid chip evacuation) or top down, with smooth arc lead-in and lead-out from hole center so the cutter never gouges the crest of the thread.
Keyhole Slots & Undercuts (T-Slot, Dovetail, Lollipop)
| Operation | Safe Entry / Exit Behavior | Typical Use |
|---|---|---|
| Keyhole | Plunges at the open entry circle, travels along the slot at full depth, then reverses back to the exact entry hole before retracting. | Flush wall-hanging slots on the back of signs and plaques. |
| T-Slot / Dovetail Undercut | Enters only in open air or pre-cleared relief, sweeps the undercut pass, and reverses cleanly out before lifting Z. | T-track hold-down jigs, sliding dovetail tabletop battens, and drawer runners. |
| 3D Lollipop Finishing | Checks vertical shank clearance against the 3D mesh BVH so spherical cutters reach beneath overhangs without colliding the neck. | Multi-sided molds and undercut 3D mechanical pockets. |
Spoilboard Surfacing, Quick Engrave, Drag Knife & Laser
- Spoilboard Surfacing: Generates a fast raster or spiral flattening pass using a 1" to 2" surfacing bit to level your MDF spoilboard or flatten rough-sawn hardwood slabs. Always add a small border overhang (e.g.,
0.5") so no unplaned lip remains around the perimeter. - Quick Engrave: Dedicated diamond-drag spring-loaded engraving with pressure Z-offset and optional cross-hatch fill for brass plaques, anodized aluminum tags, and acrylic edge-lit signs.
- Drag Knife: Automatically adds corner swivel-offset loops matching your blade offset so vinyl decals, leather, and gasket sheets cut with razor-sharp corners.
- Laser Cut/Fill & Laser Picture: Emits clean
M3/M4 S<power>diode laser commands for vector scoring, hatched fills, and dithered/grayscale photo engraving.