Speeds, Feeds & Chip Load Reference
Practical shop guide to chip load, spindle RPM, feed rate, plunge rate, and pass depth across softwood, hardwood, plywood, MDF, acrylic, and aluminum.
Good speeds and feeds are about making clean physical chips rather than fine dust. Running your router too fast (high RPM) while feeding too slowly rubs the bit against the wood, generating heat that burns dark scorch marks and dulls carbide in minutes. Feeding too fast or too deep overloads the flutes, causing chatter, deflection, or snapped bits.
The Chip Load Formula
Chip load is the thickness of the slice each cutting flute removes per revolution:
Feed Rate (IPM) = Spindle RPM x Number of Flutes x Target Chip Load (inches)
Example: A 2-flute 1/4" downcut end mill spinning at 18,000 RPM with a target chip load of 0.003" in walnut gives 18,000 x 2 x 0.003 = 108 IPM. If your machine is a lighter hobby gantry router that prefers 60 IPM, lower your spindle speed toward 12,000 RPM so the bit keeps cutting real chips instead of rubbing.
Conservative Starting Table (2-Flute 1/4" Carbide End Mill)
Use these conservative starting numbers on a rigid desktop CNC router and tune upward based on sound and chip appearance (or click Suggest for [Material] inside VibeCNC's Tool Database):
| Material | Spindle RPM | Feed Rate | Plunge / Ramp | Pass Depth | Bit Type Tip |
|---|---|---|---|---|---|
| Softwood (Pine, Cedar) | 16,000 - 18,000 | 80 - 120 IPM | 25 - 35 IPM | 0.18" - 0.25" | Downcut prevents top fuzz |
| Hardwood (Walnut, Maple, Oak) | 16,000 - 18,000 | 65 - 100 IPM | 20 - 30 IPM | 0.12" - 0.18" | Downcut or compression |
| Baltic Birch Plywood / MDF | 18,000 | 80 - 120 IPM | 25 - 35 IPM | 0.15" - 0.22" | Downcut keeps top veneer crisp |
| Cast Acrylic (Plexiglas) | 12,000 - 16,000 | 50 - 80 IPM | 15 - 25 IPM | 0.06" - 0.10" | Single-flute O-flute upcut |
| HDPE / Starboard | 14,000 - 16,000 | 75 - 110 IPM | 25 - 35 IPM | 0.12" - 0.20" | Single-flute O-flute upcut |
| 6061 Aluminum | 10,000 - 14,000 | 25 - 45 IPM | 8 - 15 IPM | 0.02" - 0.04" | Single-flute ZrN coated + air blast |
A healthy cut produces a steady low hum and warm, flaky chips (wood) or tiny shiny curls (plastic/aluminum). A high-pitched scream with fine flour dust means RPM is too high or feed is too slow; heavy thumping or rippled walls means pass depth is too aggressive or your workholding is flexing.