CAM Toolpaths

Drilling & Peck Drilling Toolpath

Bore accurate shelf-pin, dowel, and mounting holes using standard or peck drilling cycles with automatic circle filtering and dwell control.

The Drilling toolpath bores straight down along the Z axis at the exact geometric center of every selected closed vector (usually circles). It is the fastest way to produce shelf-pin grids, cribbage boards, alignment dowel holes, and spoilboard threaded-insert arrays.

VibeCNC Drilling Toolpath configuration panel
Configure peck depth, retract gap, bottom dwell, and circle selection filters in the Drilling panel.

Parameter Reference

ParameterWhat It ControlsPractical Guidance
Start Depth (D) / Cut Depth (C)Hole top and total bore depth.For blind dowel holes, bore 0.06" deeper than the dowel engagement for glue room.
Peck DrillingBreaks deep holes into short vertical plunges with chip-clearing retracts.Enable whenever hole depth exceeds 1.5x bit diameter to prevent burned wood or welded aluminum chips.
Pass Depth (Peck Increment)Depth drilled before retracting to clear flutes.Use 0.5x to 1.0x bit diameter per peck in hardwood; 0.25x to 0.5x in aluminum.
Retract Above CutRaises completely out of the hole vs a small chip-break retract.Retracting above the surface clears packed sawdust cleanly on deep cribbage or dowel holes.
Dwell at BottomBrief pause (e.g. 0.25s) at full depth.Flattens the hole floor cleanly when using brad-point or flat-bottom drill bits.

Selecting Matching Holes Automatically

On busy cabinet sheets with dozens of holes of different sizes, open the Vector Selector inside the Drilling dialog, check Only Circles, and specify a target diameter plus tolerance (for example, 5.0 mm +/- 0.1 mm). VibeCNC grabs every matching shelf-pin hole automatically and ignores larger cutouts.

Shop Safety: Drilling with End Mills

Only drill straight down with true twist drills, brad-point drills, or center-cutting upcut end mills. Non-center-cutting bits and downcut end mills pack chips underneath the tip, causing extreme heat and fire risk in wood. For holes wider than your end mill, use an Inside Profile with a helical spiral ramp instead.